Avago-technologies Cache Protection for RAID Controller Cards Manual do Utilizador descarregar pdf (Página 70)

Avago Technologies

- 70 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide

May 2015

Chapter 2: Installing the Cache Backup Products

Installing the LSIiBBU08 Unit

2.5.5.5 Installing the Remote Mount Board in the Host Computer

Follow these steps to install the remote mounting board in the computer.

1. With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is

grounded and has no AC power.

2. Insert the remote mounting board in a PCIe slot on the motherboard, as shown in the following figure.

NOTE Some PCIe slots support only PCIe graphics cards; if the remote

mounting board is installed in one of these slots, the board will not

function. Refer to your computer documentation for information

about the PCIe slot.

3. Press down gently, but firmly, to seat the board correctly in the slot.

Figure 44 Installing the Remote Mounting Board

4. Secure the remote mounting board to the computer chassis with the bracket screw.

5. Reinstall the computer cover and reattach the power cords.

6. Turn on the power to the computer.

Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the

MegaRAID SAS Device Drivers Installation User Guide for information on installing the software drivers.

85085-04

LSI 31504-00 Rev. B

Li-ion

CAUTION: Danger of explosion if battery is incorrectly replaced.

Replace with same or equivalent type recommended by manufacturer.

Dispose of used batteries according to manufacturer’s instructions.

Press

Here

Press

Here

Screw

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 138 139

Sem comentários

Avago-technologies Cache Protection for RAID Controller Cards Manual do Utilizador Página 70