Avago-technologies SAS 9300-4i Host Bus Adapter Manual do Utilizador descarregar pdf (Página 41)

LSI Corporation

- 41 -

SAS-3 Integrated RAID Solution User Guide

November 2012

Appendix A: Using the SAS-3 Integrated RAID Configuration Utility

Commands

A.3.13.1 Command Line

sas3ircu <controller_#> bootir <volumeID>

A.3.13.2 Parameters

 <controller_#> – The index of the controller with the RAID volume that you want to select as the primary

boot device.

 <volumeID> – The volume ID of the RAID volume that you want to select as the primary boot device.

A.3.13.3 Program Return Value

0x00 SUCCESS: Command completed successfully.

0x01 FAILURE: Bad command-line arguments or operational failure.

0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.

A.3.13.4 Sample Output

Following is an example of the output of the BOOTIR command, showing a RAID volume as the primary boot device,

after it was selected with the BOOTIR command. The format and fields in the output vary depending on the types of

installed controllers.

------------------------------------------------------------------------

IR Volume information

------------------------------------------------------------------------

IR volume 1

Volume ID : 174

Status of volume : Degraded (DGD)

RAID level : RAID1

Size (in MB) : 69376

Boot : Primary

Physical hard disks :

PHY[0] Enclosure#/Slot# : 2:8

PHY[1] Enclosure#/Slot# : 2:11

------------------------------------------------------------------------

A.3.14 BOOTENCL

The BOOTENCL command selects a specific enclosure/slot as the primary boot device. If an enclosure/slot is selected

as the boot location, the DISPLAY command displays this information in the Enclosure information section.

A.3.14.1 Command Line

sas3ircu <controller_#> bootencl <Enclosure:Bay>

A.3.14.2 Parameters

 <controller_#> – The index of the controller with the enclosure/slot that you want to select as the primary

boot device.

 <Enclosure:Bay> – The enclosure:bay value of the disk drive that you want to select as the primary boot

device.

A.3.14.3 Program Return Value

0x00 SUCCESS: Command completed successfully.

0x01 FAILURE: Bad command-line arguments or operational failure.

0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.

1 2 ... 36 37 38 39 40 41 42 43

Comentários a estes Manuais

Sem comentários

Avago-technologies SAS 9300-4i Host Bus Adapter Manual do Utilizador Página 41

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Avago-technologies SAS 9300-4i Host Bus Adapter